2 inch Lift Kit for 1986-1989 Toyota 4Runner 4WD


Found a better price?
SKU: IFS2-87RUN Categories: , Brand:


2 inch Lift Kit for 1986-1989 Toyota 4Runner 4WD


  • Fits Toyota 4Runner 4×4 1986, 1987, 1988, 1989 4WD

Included in kit:

  • 2″ Lift Front Spacers– CNC Machined From T-6 6061 Aluminum. 8 ball joint bolts.
  • 2″ Lift ToyTec rear add-a-leafs.
  • Install Directions.
  • BPV extension Bracket.



There are no reviews yet.

Be the first to review “2 inch Lift Kit for 1986-1989 Toyota 4Runner 4WD”

Questions and answers of the customers

  1. Answered by the admin Yes sir. All hardware is included
  2. Answered by the admin This item is a suspension lift. Unfortunatelly we have no body lift kits for 1986-1989 4Runners - only for next gens 4Runners body lift kits are available.
  3. Answered by the admin This kit will raise both front and rear ens of the truck approximately by 2'' . so maybe you'll need only the rear lift without raising the front with the help of these: https://bilsteinlifts.com/shop/toyota-4runner/1986-1989/rear-procomp-aals-firm-ride/ The best way to figure out is to take measurements from the wheel center to the fender line for the front and for the rear, when the truck is standing on the flat ground.
  4. Answered by the admin The recomendations will be to get the shocks with extended length 2'' more then the stocks shocks
  5. Answered by the admin We can't say exactly because we haven't tested it fitment. It will depend on wheel rims offset and on the suspension condition, also on if you carry much weight on the front or not. Maybe the fender trim will be required to run 33'. We recommend test fitment before using non-standart wheels.
  6. Answered by the admin No, Bilstein 5100 would be too long for that kit.
  7. Answered by the admin No, this does not fit - pick up has some differences.

Send me a notification for each new answer.
ATTENTION STATE OF CALIFORNIA CONSUMERS. WARNING: Cancer and reproductive harm – www.p65warnings.ca.gov