Toytec 0-3″ Lift Kit For 2008-2020 Toyota Sequoia
Toytec 0-3″ Lift Kit For 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020 Toyota Sequoia
Front Boss Coilovers:
- Adjustable from 0 to 3″ front lift.
- Pre set to approximately 3″ of lift.
- Front BOSS Shocks have a Heim lower bushing and Heavy duty 5/8″ nitro steel shaft
- Unbeatable ride quality on and off road
- Front bolt on lift, no spring compressor needed.
- Choose between 700lb Silver or Red coils
- Includes spanner wrench for ride height adjustment.
- Sold as a pair
- Included to allow for proper shock travel. Note: This must be installed or warranty will be voided.
- TU-DR-07 – For 4wd models – Designed to reduce the front cv axle angles on a lifted 4×4.
- Rear 2” lift OME coils to give you the correct rear height while maintaining 1” of rake with 3″ of lift in the front.
- Rear Bilstein 5125 Shocks with Energy Suspension bushings and misalignment spacers to retain proper travel in the rear.
- If you do a lot of heavy hauling or towing please let us know so we can get you a heavier valved shock.
- Two rear 1/8” Bump Stop spacers.
- Also includes one 80PR10 – Rear OME10mm trim spacer to be installed on the drivers side rear coil spring. This is designed to correct the driver side lean common on Toyota trucks and SUV’s.
Add Upper Control Arms to complete your kit:
- SPC Adjustable Upper Control Arms – 25490 – The most adjustable UCA on the market. Correct your alignment angles. Also great for adjusting for tire clearance.
- Total Chaos Uniball Upper Control arms – 87500 – Maximize your wheel travel and increase your strength while also correcting alignment angles.
- 2008+ Sequoia
- Will not fit vehicles equipped with AVS or TEMS
- Kit installation requires use of OEM Automotive Tools Coil Spring Compressors 27035 or something similar