Solid Steel Axle Degree Shims

Rated 4.75 out of 5 based on 4 customer ratings
(4 customer reviews)

$49.99

Found a better price?

Description

TT3DS

– Machined from solid steel and are zinc plated for a long lasting finish.
– These 3 degree shims bolt to the bottom of your leaf pack using the included new leaf spring center bolts.
– Axle degree shims are ideal for Add-A-Leaf and Leaf Pack installs to minimize or eliminate rear drive line vibration.
– Degree shims are perfect for 2″ to 3″ rear lift.

Included in kit-
(2) 3 Degree axle degree shims
(2) Leaf spring center bolts W/ hardware

* May require longer U bolts on some models.

**NOTE- Please order TT-RS-846 shims for use with Toytec rear lift block kits

4 reviews for Solid Steel Axle Degree Shims

  1. Rated 5 out of 5

    Bryan Knodel

    Best if used with carrier bearing drop kit. Easy install and performing great.

  2. Rated 5 out of 5

    MV

    Pretty easy to install, I brought the add-a-leaf, all this takes little patience to realign the leafs and each of their holes, second time around got easier. I bought the diff drop kit as well, I have not installed it yet. The angle is slight, so I will probably end up installing that soon. Not absolutely needed but short time and money. Good luck.

  3. Rated 5 out of 5

    Todd

    A must for lifted Tacomas! I wish I had bought these before doing my lift as now I have to undo the leaf springs again to put these on. if your lifting your truck put these in when adding the add a leafs and save yourself some time and trouble of having to do this part again. and when you buy these, also get the Driveshaft Carrier Bearing Drop Kit and you should have all you need to correct the driveline angle and get rid of that small vibration.
    BilsteinLifts was great to order from, good prices and got them delivered fast, Thanks

  4. Rated 4 out of 5

    Jack Schnabel

    Parts seem to be good quality. Haven’t had a chance to install yet. What I didn’t care for was the amount of time it took to fill the order and receive an email that the order was on its way. Otherwise satisfied with the order.

Add a review

Questions and answers of the customers

  1. Answered by the admin The center pins are slightly bigger than factory and longer, width is about 3.5 to 4 inches
  2. Answered by the admin you can order this item * * * https://bilsteinlifts.com/shop/toyota-tacoma/1995-2004/zinc-axle-degree-shims/ * * * with 2 degree option
  3. Answered by the admin It will not make any great noticeable amount of lift - only to make driveshaft be more flat and smooth at 1-2 degrees
  4. Answered by the admin We do not have that information unfortunately.

Send me a notification for each new answer.
ATTENTION STATE OF CALIFORNIA CONSUMERS. WARNING: Cancer and reproductive harm – www.p65warnings.ca.gov