Driveshaft Carrier Bearing Drop Kit for 2005-2019 Toyota Tacoma

SKU: FK29
5 out of 5 based on 11 customer ratings
(11 customer reviews )
Found a better price?

$29.99

In Stock

Description

Driveshaft Carrier Bearing Drop Kit for 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019 Toyota Tacoma

FK29

Used to straighten drive line angles on 05-17 Toyota Tacoma trucks.

Lowers the carrier bearing to minimize the rear driveline angles.

Can be used in conjunction with shims (TT-RS).

Instructions included.

Old Man Emu Fitment Kit FK29 (Driveshaft Spacer for Vibration Correction when lifting)

ships USPS priority if ordered separately

FK29 Installation Instructions

Customer reviews

Rated 5 out of 5 stars
11 reviews
4 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %

11 reviews for Driveshaft Carrier Bearing Drop Kit for 2005-2019 Toyota Tacoma

    Add a review

    Use one of the allowed file type: jpg,png.

      Questions and answers of the customers

      1. 0 votes
        Answered by the admin You can go without it but with rear lifts 2'' and more some trucks experience drive shaft vibrations
      2. 0 votes
        Answered by the admin We actually don't offer a a driveshaft carrier bearing for 1st gen Tacomas
      3. 0 votes
        A No, this is for the rear driveshaft. Will not make a change in front end steering issues.
      4. 0 votes
        Answered by the admin No special specs, just tighten the bolts properly
      5. 0 votes
        Answered by the admin This item will help to normalize driveshaft angle
      6. 0 votes
        Answered by the admin 3/4 to 1/2 of an inch. I do not have the exact measurements
      7. 0 votes
        Answered by the admin Haven't tested it by ourselves. I'd try one kit first, because two kits will ake transmission-to driveshaft angle bigger then one kit
      8. 0 votes
        Answered by the admin Can't say that exactly necessary, but is recommended for many cases
      9. 0 votes
        Answered by the admin Will depend on the driver shaft condition. One item is enough for up to 3'' lift in most cases.
      10. 1 vote
        Answered by the admin It is not the bad idea to install it, but the truck can go without it. But the vibrations may be lower and the carrier bearing will live longer when this item is installed.
      11. 1 vote
        Answered by the admin According to ARB, The FK29 is a 3/8" spacer

      Send me a notification for each new answer.